LED system

Radio LED

Behavior	Description
Steady ON blue	Pairing procedure with remote device on going.
Blinking blue	IRC communication active.

Results LEDs

Signaling LED	Behavior*	Strategy	Description
OK LED	Steady ON green	Tool test	Single test result OK.
nxOK LED	1 long blink yellow + 1 long pause	-	The date/hour is not set. Connect the IRC-Connect either to an STa 6000/STa 6000 Plus, to ToolsTalk BLM software or to QAT Calibrator software to synchronize date and hour. Do not make any measurement with the IRC-Connect.
nxOK LED	Steady ON yellow	Tool test	Batch of tests completed with OK results.
NOK LED	Steady ON red	Tool test	Single test result NOK.
NOK LED	1 long blink red + 1 long pause	All	The transducer has been overloaded. Reboot the IRC connect to double-check the Zero.
NOK LED	1 short blink red + 1 short pause	All	Transducer Zero Torque error, or Gyroscope Zero error. Reboot the IRC connect to double-check the Zero.
NOK LED	2 short blinks red + 1 long pause	All	At least one Pset parameter is not compatible with the transducer minimum load, or at least one Pset parameter is not compatible with the transducer capacity.
NOK LED	3 short blinks red + 1 long pause	All	The transducer connected to the IRC-Connect is not compatible with the Pset.

*Meaning of the main LED behaviors:

Steady ON	1 short blink + 1 long pause	1 long blink + 1 long pause	2 short blinks + 1 long pause	3 short blinks + 1 long pause

Measurement LED

Behavior	Description
Steady ON red	The IRC-Connect is powering on.
Blinking red	Measurement on going.

Battery LED

Behavior	Description
Steady green	Battery charge over 50%.
Steady yellow	Battery charge between 25% and 50%.
Steady red	Battery charge between 10% and 25%.
Blinking red	Battery charge below 10%.
Blinking green	Battery under charge (charge level below 95%). If the IRC-Connect is switched off, the Battery LED is also off, but the battery gets charged anyway.