Tool inspections

The Inspection category assigns the test type according to the tool previously specified.
The maximum number of Inspections per Tool is 60.
The device assigns the following inspections:

Cm/Cmk ISO: it makes a Cm/Cmk test through the ISO statistics to evaluate the tool capability.
SPC: it is a method of quality control in which statistical methods are used. It makes a series of tests to evaluate an average value to be compared with successive mean values on the X/R chart. By analyzing these points in sequence it is possible to monitor and control the process.
ISO 5393: it makes a test with the selected tool in compliance with the ISO 5393 standards. For more information, see “ISO 5393 International Standard – Second Edition 1994-05-01”.
ISO 6789:2003: it makes a test with the selected tool in compliance with the ISO 6789 standards. For more information, see “ISO 6789 International Standard – Third Edition 2003-04-01”.
ISO 6789-2:2017 : it makes a test with the selected tool in compliance with the ISO 6789:2017 standards. For more information, see “ISO 6789-2:2017 International Standard ”.
CAM/Cpk CNOMO: it makes a Cm/Cmk test through the CNOMO statistics to evaluate the tool capability. For more information, see “CNOMO International Standard (E41.32.110N) – Edition July 1990”.
Calibration: it makes a calibration test to evaluate the tool capability. The calibration test calibrates power tools and pulse tools.
VDI/VDE 2645-2: it makes a test with the selected tool in compliance with the VDI/VDE 2645-2 standards. For more information, see “VDI/VDE 2645-2 – September 2014”
JJF 1610-2017: it makes a test with the selected tool in compliance with the JJF 1610-2017 standards. For more information, see “JJF 1610-2017 - 2017-05-28”.

Below is a list that links each tool type with the related available inspections:

Click wrench: Cm/Cmk ISO, SPC, ISO 6789, ISO 6789-2:2017, and CAM/Cpk CNOMO.
Power tool: Cm/Cmk ISO, SPC, ISO 5393, CAM/Cpk CNOMO, Calibration, VDI/VDE 2645-2 (only for motorized tools, continuously rotating), JJF 1610-2017.
Peak: Cm/Cmk ISO, SPC, ISO 6789, ISO 6789-2:2017 and CAM/Cpk CNOMO.
Pulse tool: Cm/Cmk ISO, SPC, CAM/Cpk CNOMO and Calibration.

It is possible to save two inspections with the same name and the same target objet. A warning message is displayed to inform the operator that an inspection with the same name already exists.
Select Yes to save the inspection.
Select No to cancel the inspection.