Hydraulic installation
With the equipment disconnected from the main supply, connect the hydraulic tool to the hose and then the other end of the hose to the pressure equipment.
A | High pressure connector (Advance ) | B | Low pressure connector (Return) |
Lay the hoses in a way that they are not too tight or stretched, subject damage, and out of the passing vehicles area. Always respect the minimum radius of curvature of the hoses (a minimum of five times its nominal diameter).
The unit is supplied ready for use with the exception of the hydraulic oil. Before every use, make sure it has the adequate amount of oil in the reservoir. If necessary, top it up only with oil of the recommended characteristics (see chapter IV-2), always respecting the minimum and maximum levels indicated (see chapter III-3). Wear protective gloves, eliminate any spillage immediately and clean the surfaces with degreaser.
Use the hoses and connection elements of the recommended characteristics and without any wear and tear (worn exterior coat, bents, deformed, worn out or rusty connectors, etc).
