Teaching Existing Workpieces / Groups

In the Configuration mode, on the Tightening Positions page, in the Tightening Positions list select an existing workpiece / group.

At the top of the Tightening Positions page, select the Teaching button. The Teaching pop-up window appears.

In the Teaching pop-up window, cancel the Reteaching selection.

Put the tool on the necessary tightening position. Then, press the tool trigger shortly.
After each trigger signal, a message appears.
Confirm the information on the successful teaching and move on to the next tightening position. Repeat this step for all the necessary tightening positions.

A possible warning about tool being disabled is not important as the teaching process does not require tightening.

The names of the positions are created by adding a consecutive number to the name of the workpiece / group. Thus, always define the workpiece / group names before the Teaching process.

At the top of the Tightening Positions page, select the Teaching button to stop the Teaching process.