item | item | none |
3.13 | | NEW content: UPDATED content: |
3.11 | 02/2024 | NEW content: UPDATED content: Configuring Live Result Presentation Settings General Settings Front End Information Tool LEDs Tool Diagnostics Multistep Configuration User Interface Event Codes Settings for a Multistep Program Step Monitors Tightening Steps Step Restrictions Terms and Definitions NOK Results List PCH - Pulse Count High "StepSync" replaced with "controller" or "synchronized tightening"
|
3.10 | 06/2023 | NEW content: UPDATED content: Event Codes Output Signals PrT - Prevailing Torque Open Protocol Choosing Accessories Hardware Start-up Progress Indications Software Update Troubleshooting Exported Information and File Format General Settings
|
3.9 | 01/2023 | NEW content: UPDATED content: Connecting to a Power Focus Controller (IxB Connect) Exporting "System Logs and Information" Event Codes list: Event Codes Tightening steps: Tighten to Torque and Angle, Tighten to Torque or Angle General Virtual Station Step monitors: A - Angle, PTCA - Post Thread Cut Angle
|
3.8 | 06/2022 | NEW content: Enabling the IxB tool to connect to a Power Focus 6000, or Power Focus 8 controller: Connecting to a Power Focus Controller (IxB Connect) Exporting system logs and information: Exporting "System Logs and Information" Hardware compatibility check at software update: Update Software Version Extended information on hardware modules: Hardware New input signal Set Zero Position - 10135: Input Signals New output signal Tools in Zero Position - 210: Output Signals
|
3.7 | 01/2022 | NEW content: New Events for board supervision and wrong power source (Event codes 2200 - 2210): Event Codes New output signals: 208 - ToolsTalk connection lost, 206 - Confirm loosening: Output Signals Strategies for returning an open end tool to open position after tightening: Open End Configuration New start-up progress information for tools equipped with EHMI: EHMI Start-up Progress Indications Program monitor Time, and program restrictions Angle and Time: Tightening Program Properties Step monitor Current: Step Monitors Step restriction Current: Step Restrictions Extended logging using log groups: Configuration of the Extended Logging, Configuring the Remote Logging Connection
|
3.6 | 06/2021 | NEW content: Configurable tool vibrator: 5. Vibrator Configuration of dual transducer tools: Dual Transducer Tool Calibration (TC) tightening step and monitor: Tightening Steps, Step Monitors
UPDATED content: |
3.5 | 12/2020 | NEW content: Function for configuration of WLAN channels: Configuring Channels Function for Statistical Process Control (SPC): SPC - Statistical Process Control Function for configuration of result presentation: Configuring Result Presentation Settings Function for configuration of user permissions: Configuring the PIN Settings Function for viewing server connection status: Viewing Protocol Status Function for synchronizing traces: Viewing Synchronized Traces Function for clearing results: Performing Factory Reset and Clearing Results
|
3.4 | 07/2020 | NEW content: Open end tuning function: Open End Tuning Tightening program selection: General Settings Software update troubleshooting: Software Update Troubleshooting Maximum number of steps in a tightening program: Adding a Tightening Program Trace Settings: Step Parameters
|
3.3 | 03/2020 | First release |
