Maintenance

The tool stores a service interval number and counts how many tightenings that can be performed before a tool maintenance or service is needed.

Set a service interval
  1. Go to Integrated Controller Tool in the home and select Tool in the left pane.

  2. Expand the Maintenance field. The following information is displayed:

    Parameter

    Description

    Last service

    Date and time when last service was performed. The Last service date is set at the repair workshop. The Last service date is set to current date and time when the Reset service counter button is pressed.

    Total tightenings at service

    Total number of tightenings performed by the tool since it was used for the first time. This value is made available at service, and will remain the same until next service.

    Remaining tightenings

    Total number of tightenings left until the service interval is reached.

    Service interval

    Number of tightenings to be performed between two service events. Can be set in multiples of 10 000.

    Reset service counter

    Reset of the Remaining tightenings counter and sets Last service date to current date.

  3. Set a value in the Service interval field.

    The Service interval number can only be set in multiples of 10 000. Any number other than multiples of 10 000 will be rounded off to the nearest multiple of 10 000.

  4. Select OK.

To enable the maintenance alarm, go to Settings > Alarms > Maintenance and set the Service alarm indicator to On.