Dimensions and weight

Product	L* [mm]	K [mm]	X [mm]	Y [mm]	Z [mm]	H [mm]	Weight** [kg]	E [mm]
STRwrench Controller Compact + smartHEAD 15 Nm	374	437	145	278	13.4	356	1.41	9x12
STRwrench Controller Compact + smartHEAD 80 Nm	374	437	145	278	13.4	356	1.44	9x12
STRwrench Controller Compact + smartHEAD 250 Nm	499	554	262	278	13.4	473	2.04	14x18
STRwrench Controller Compact + smartHEAD 250 Nm Long	699	754	462	278	13.4	673	2.15	14x18
STRwrench Controller Compact + smartHEAD 400 Nm	820	874	583	278	13.4	795	2.79	14x18
STRwrench Controller Compact + smartHEAD 500 Nm	825	874	583	278	13.4	795	3.24	14x18
STRwrench Controller Compact + smartHEAD 600 Nm	1335	1352	1061	278	13.4	1272	4.62	21x26
STRwrench Controller Compact + smartHEAD 800 Nm	1335	1352	1061	278	13.4	1272	4.77	21x26
STRwrench Controller Compact + smartHEAD 1000 Nm ALU	1544	1470	1178	278	13.4	1390	8.42	Ø28
STRwrench Controller Compact + smartHEAD 1000 Nm CAR	1667	1593	1301	278	13.4	1513	6.36	Ø28

*Dimension L is the standard arm, measured from the center of the handle to the center of the end fitting tool. This information is used to calculate the Torque Correction Coefficient when an extension is used. This dimension is calculated for the standard Atlas Copco end fitting tools used during calibration (L-H); if a different end fitting tool is used, this measure must be recalculated.
Refer to STRwrench Firmware User Guide for more information.

Extension length must be less than half of the wrench length including smartHEAD (L/2). If not, a new calibration is recommended.

Weight includes a controller compact, battery, smartHEAD and standard end fitting tool.