SPC Rules

  1. In the Home page, tap Configuration > Inspection values > SPC Rules. The following is displayed:

    A

    Categories

    B

    Save button

    C

    Drop-down menu

    D

    Check boxes

  2. On the right side of the SPC rules page, tap the check boxes to enable/disable the necessary SPC rules.

    It is possible to configure different sets of rules for the Tool check, Joint check, and Dimensional check inspections by selecting the category of interest.

  3. From the Show SPC rules summary popup drop-down menu, select one of the following items:

    • Always: to always display the SPC rules summary popup with all the SPC rules.

    • NOK only: to display in the SPC rules summary popup only the NOK SPC rules.

    • Never: to never display the SPC rules summary popup.

    It is possible to configure different SPC Popup Display mode for the Tool check, Joint check, and Dimensional check inspections by selecting the category of interest.

  4. On the upper-right corner of the SPC rules page, tap Save.

Relevant Information