Revision History

item

item

none

3.13

09/2024

NEW content

• Configuration of HTTPS

• Configuring HTTPS

• Zero Offset and Shunt

• Transducer Information

• Certificates

UPDATED content

• Calibrating the Tool

• Event Codes

• Start Source

• List of Third-Party Licenses

• Configuration of the Multiple Transducers

• Tool Diagnostics

• TC - Torque Calibration

• TC - Torque Calibration

• DT – Tighten to DynaTork

• Configuring the ToolsTalk Connection

• Configuring the ToolsNet Connection

• Configuring a Source Tightening

3.11

01/2024

UPDATED content

• Event Codes

• NOK Results List

• Configuration of the Tool LEDs

• Pairing a Wireless Tool to a Controller replaces the section WLAN and Bluetooth for Wireless Tools.

• General Virtual Station information about enable and disable loosening/tightening changed. Additional information to General Virtual Station updated: Configuring Live Result Presentation Settings and Configuring the storage of Final Torque and Trace

• Stepsync replaced with either controller or Synchronized tightening in the whole User guide.

REMOVED content

• The section Configuration of the Wireless Settings removed from Working with the Settings Tab.

3.10

06/2023

NEW content

• Troubleshooting Matrix added in Troubleshooting and Service

UPDATED content

• Exporting "Logs from Connected Tools" QST-M added

• PrT - Prevailing Torque

• Event Codes Battery status added

• Tool Diagnostics Diagnostic test added

• Configuring Protocols Window in a Virtual Station Communication timeout value added

3.9

01/2023

NEW content

• Configuration > Working with the Tool Tab > Tool Diagnostics

• Configuration > Working with the Tool Tab > Zero Position

UPDATED content

• Configuration > Working with the Tightening Tab > Multistep Programs > Step Monitors

• Configuration > Working with the Configurations Tab > General Virtual Station

3.8

06/2022

NEW content

• Configuration > Working with the Controller Tab > Export/Import > Exporting "System Logs and Information"

UPDATED content

• Reference > Input Signals

• Configuration > Working with the controller tab > StepSync > StepSync Signals > Input Signals: Sub-signals

• Reference > Output Signals

3.7

01/2022

NEW content:

• Configurations Tab > Tool Configuration > Configuration of the Open End

• Settings Tab > Configuration of the Protocol > Configuring the Remote Logging Connection

• Settings Tab > Configuration of the Extended Logging

• Settings Tab > Configuration of the Extended Logging > Configuring the Log Groups

UPDATED content:

• Multistep Programs > Step Monitors (C - Current)

• Multistep Programs > Settings for a Multistep Program (Program Monitor - Time, Program Restriction - Angle, Program Restriction - Time)

• Multistep Programs > Step Restrictions (C - Current)

• Event Codes list

• Input Signals - Power Focus XC

• Output Signals - Power Focus XC

3.6

06/2021

First official release of the user guide for Power Focus XC.