Configuring the WLAN

On the Wireless Settings tab , go to the WLAN properties. To configure the WLAN, the Wi-Fi state selection has to be set to Enabled, this will open the WLAN properties for further configuration.

Properties	Setting
Wi-Fi state	Enabled Disabled
SSID	Wi-Fi Network name to connect to
Tool name	Enter a Tool name that will be visible on the router
IP configuration	DHCP Static IP: Tool IP address Subnet mask Default router
Security mode	No security WPA-PSK, TKP WPA-PSK, AES LEAP: PEAP: Validate Server CA certificate EAP/TLS: Validate Server CA certificate
Key format	Binary (hex-format) Printable ASCII
Password	Enter password, length of string 8-63 characters

Relevant Information

Pending Changes
Reading Data from a Device
Uploading a Certificate
Writing Data to a Device