Upgrading ToolsTalk 2
Before ToolsTalk 2 is upgraded from an earlier to a later version, choose one of the three different upgrade paths that are described on this page.
Upgrading from 2.12 or earlier–2.13
If ACDC is installed, make sure that the controller port is the same as where ACDC was installed.
If ACDC will be installed and you want to use a different controller port than the one for ToolsTalk 2, change the controller port as follows:
Open one of the following files:
C:\Program Files\Atlas Copco\ToolsTalk Server\ToolsTalk.Server.SelfHostService.exe.config(ClickOnce/Client/Server)C:\Program Files (x86)\Atlas Copco\ToolsTalk StationSetup\ToolsTalk.Standalone.exe.config(Station Setup)
Find the line that contains the following text:
<add key="HubPort" value="{port_number}" />Change the port number.
Save the file.
Upgrading from 2.13–2.20
Before the upgrade is started:
Make sure that the ToolsTalk 2 server is running.
Back up the ToolsTalk 2 database.
Make sure that .NET Framework is installed.
Upgrading from 2.20 to 2.21
Before the upgrade is started:
Make sure that the ToolsTalk 2 server is running.
Back up the ToolsTalk 2 database.
Make sure that .NET 6 is installed.
Make sure that Atlas Copco Data Communication (ACDC) is version 2.5 or later
Make sure that existing ToolsTalk 2 clients are uninstalled.
After the upgrade has finished, install ToolsTalk 2 clients, version 2.21.
Upgrading from 2.21–later
Before the upgrade is started:
Make sure that the ToolsTalk 2 server is running.
Back up the ToolsTalk 2 database.
Make sure that .NET 8 is installed.
