Running a Loosening Sync Mode

A loosening sync mode can be run in following possible ways.

All the conditions to start a tightening must be fulfilled (example: no emergency stop, enable signal is set and so on) in order for all the above cases to work correctly.

Running a Loosening Sync Mode Using the Input Select Loosening

Select a tightening sync mode with an associated loosening sync mode.
- This can be done by adding the I/O signal Select Input, Id 10020 in the To controller area in the Fieldbus sub-tab under Fieldbus and SoftPLC or this can also be done by selecting a task in the Task under the Virtual Station tab .
Select loosening using the I/O signal Select loosening, Id 10029 in the To controller area in the Fieldbus sub-tab under Fieldbus and SoftPLC .
Start the loosening using any of the two signals:
- Start drive (continuos), Id 10028
- Start drive (pulse), Id 10113

Running a Loosening Sync Mode Using Input Start Loosening

Select a tightening sync mode with an associated loosening sync mode
- This can be done by adding the I/O signal Select Input, Id 10020 in the To controller area in the Fieldbus sub-tab under Fieldbus and SoftPLC or this can also be done by selecting a task in the Task under the Virtual Station tab .
Start the loosening using any of these two signals:
- Start loosening (continuous), Id 10011
- Loosening pulse start (pulse), Id 10072