Setting the Intermediate Position of the Stroke Module
WARNINGElectrical hazard
Turn off mains power supply before adjusting or servicing.
WARNINGRisk of severe injury
Air under pressure can cause injury.
Always shut off the air supply when not in use or before any adjustments.
Drain the hose of air pressure and disconnect the tool from air supply when not in use or before any adjustments.
Always use the correct hose size and air pressure for the tool.
Normally the setting is factory preset.
The intermediate position for the Stroke Module must be adjusted if
The screw is pushed out to the front - stroke is too long. In this case, the Sleeve must be turned to the right to bring it further backwards.
The screw drops from the Feeding Head - stroke is too short. In this case, the Sleeve must be turned to the left to bring it further forwards.
To adjust the intermediate position, two special adjustment tools are needed, which can engage in the grooves of the sleeves. In this case, the outer Threaded Ring counters the inner Threaded Sleeve.
Adjustment
Remove the Feeding Head by retracting the Quick-Change Coupling.
Unscrew the outer Threaded Ring, hold the inner Threaded Sleeve with the smaller Wench and unscrew the outer Ring with the larger Wrench.
Then, the inner Threaded Sleeve can be turned in or out, with one revolution 5/10 mm displacement of the Sleeve forwards or backwards, depending on the direction of rotation.
After adjustment, it must be countered with the outer Threaded Ring again.
Reinstall the Feeding Head.
