Cleaning and Replacing the Feeding Head

WARNING

Electrical hazard

Turn off mains power supply before adjusting or servicing.

WARNING

Risk of severe injury

Air under pressure can cause injury.

  • Always shut off the air supply when not in use or before any adjustments.

  • Drain the hose of air pressure and disconnect the tool from air supply when not in use or before any adjustments.

  • Always use the correct hose size and air pressure for the tool.

Removing the Feeding Head

The Screw Feeding Tightening Module always has to be repaired in case of damage. An inadequately maintained Screw Feeding Tightening Module is a source of danger.

  • Pull the Sleeve of the Quick-Change Coupling (blue) backwards, and then pull off the Feeding Head (green).

Cleaning and checking the Feeding Head

  • Thoroughly clean the entire Feeding Head of any adhering dirt with a commercially available industrial cleaner and a cloth.

  • Visually inspect the Feeding Head and check for damage. If damaged, the Feeding Head or the damaged components must be replaced.

Mounting the Feeding Head

  • Push the Swivel Arm aside and pull the Sleeve of the Quick-Change Coupling backwards.

  • Attach the clean, or the new, Feeding Head and then release the Sleeve of the Quick-Change Coupling.

  • Make sure that the Feeding Head is correctly attached by turning and pulling gently. The Feeding Head should remain attached to the Screw Feeding Front Part.