Transducer Information
Only available for QST and IxB tools.
A tool can have several torque and angle transducers depending on tool type. An image shows the position of the transducers.
Select Details for more information about the torque or angle transducers. Depending on transducer type the following information can be available.
Information | Description |
|---|---|
Status | Indicates the status of the transducer. |
Gear ratio | The gear ratio between the transducer and the out-going shaft of the tool. |
Wind-up | The wind-up compensation factor for the angle transducer. |
Enabled | Use the toggle to enable or disable the transducer. |
Information | Description |
|---|---|
Status | Indicates the status of the transducer. |
Calibration Value | Calibration value for the transducer expressed in Nm. |
Enabled | Use the toggle to enable or disable the transducer. |
