IA - Impulse Tighten to Angle / Loosen to Angle

Tools
IXB

Impulse steps are valid only for IPB-P tools.

Impulse Tighten to Angle

This step generates tightening pulses in the forward direction, until the target angle is reached.

Impulse Loosen to Angle

This step generates tightening pulses in the backward direction, until the target angle is reached.

Parameter	Description
Angle Target - Ts	Angle Target must be greater than 0.
Pulse Energy - Pe	Pulse Energy is used to control the amount of energy/current in each pulse. Pulse Energy must range from 10% through 100 %. Default value: 100%.
Auto Speed	On: The tool will run at impulse energy speed both when pulsing and not pulsing. The pulse energy speed will be used through the whole step. Off: The tool will run at the entered speed when not pulsing and at impulse energy speed when pulsing. Different speeds will be used within the step.

Parameter

Description

Angle Target - Ts

Angle Target must be greater than 0.

Pulse Energy - Pe

Pulse Energy is used to control the amount of energy/current in each pulse.

Pulse Energy must range from 10% through 100 %.
Default value: 100%.

Auto Speed

On: The tool will run at impulse energy speed both when pulsing and not pulsing. The pulse energy speed will be used through the whole step.
Off: The tool will run at the entered speed when not pulsing and at impulse energy speed when pulsing. Different speeds will be used within the step.