Tool Diagnostics

Diagnostic tests

To find out if a tool works correctly it is possible to do a diagnostic tests of the tool. The type of test that can be run depends on which tool is connected. Three different types of tests can be run:

Automatic production test: No action is required from the user.
Manual tests with no acknowledgment: The user has to do some tasks during the test.
Manual tests with acknowledgment: The user has to monitor and give feedback on the tool´s behavior.

It is only possible to start one diagnostic test for each tool and controller at a time.

When the diagnostic test is started the session is locked for other clients. A diagnostic test session has a time out of 20 minutes. A warning is shown 5 minutes before timeout and it is then possible to extend the session or to stop it.

Diagnostic test information
Automatic production test	Manual test with no acknowledgment	Manual test with acknowledgment
Transducer shunt check Transducer shunt check for Front Transducer MRT mainboard status Backup battery status Power module status EHMI connected	Start button/Trigger Reverse ring/switch or button Function button RHMI button	Speaker/Buzzer Vibrator BHMI LEDs RHMI LEDs Front light Front light colors Fan

Start a diagnostic test session

Go to the Integrated Controller Tool in the home menu and select Tool in the left pane.
Select Diagnostic Tests in Diagnostics.
Turn on Diagnostic Tests.
Select the test you want to run.
Follow the instructions on the screen.
All tests show result with green or red indication.
The diagnostic test times out if no action is done within 5 seconds.
A diagnostic test result is shown when the a test session is completed.
If you leave the diagnostic test page the result will disappear!
To export a test result; select the Export button.