1. IxB Software
2. Configuration
3. Configuration Options

Configuration Options

The configuration and setting up of the tool can be done in the following ways:

• IxB Software:The tool can be directly connected to a PC via a USB cable. If the tool is connected to a wireless network and its IP address is known, it can be accessed from a computer anywhere on the network.

• ToolsTalk 2: If the tool is connected to a ToolsTalk 2 server, a ToolsTalk 2 client (PC) can access all connected tools and controllers through ToolsTalk 2. IxB tools, as well as Power Focus 6000 controllers and Flex controllers can be accessed.

• ToolsTalk 2 in Station Setup mode: Provides a ToolsTalk 2 interface on a PC without a server installation. The PC is connected to the controller service port and provides access to one controller at a time.

• Controller: This is applicable to Power Focus 6000 controllers which have a touchscreen. A controller can be configured regardless whether it is connected to the network or not.

This user guide covers the IxB Software. For information about ToolsTalk 2 and Power Focus 6000, refer to ToolsTalk 2 User Guide and Power Focus 6000 User Guide.