1. Industrial Location Guidance (ILG)
2. Configuration
3. Working with Setup Mode
4. Settings Page
5. General Tab

General Tab

Bypass Tool Lock Mode

In the Bypass Tool Lock Mode section, it is possible to enable an unlocking mode for all tools. Using this mode will result in all tools being unlocked without position control/process security. All workpieces will be stopped from running. A banner will be shown to indicate that the Bypass Tool Lock Mode is active. For instructions on how to enable the mode and unlock all the tools, refer to the Bypassing Locks chapter.

The Bypass Tool Lock Mode should be used with caution! Make sure all users are aware of its effect on the processes.

It is also possible to use a specific Pset or to trigger an I/O signal when the Bypass Tool Lock Mode is used, refer to the Advanced Section Configuration chapter for instructions.

Station

In the Station section, the ID, Name, Description, and Location are shown for the station. To change any values in the Station section, select the icon and enter new values.

HTTP

In the HTTP section, the http port can be changed by selecting the icon and entering a new port number.

Websocket

In the Websocket section, the websocket port can be changed by selecting the icon and entering a new port number.

If the websocket port is changed and the connection type is ASDK remote the same port needs to be set for the controller on the Tools page, in the Controller section, in the Port box.