Tool Tab

The initial configuration Assistant simplifies the basic configuration of the ILG software to set up the communication interface to the sensors and the tightening controller. At the beginning of any system setup, use the assistant to decrease the setup effort.

The buttons at the upper-left corner of the Tool tab can be used to make changes to an existing tool, delete a tool, release a tool, lock a tool or reset locks.

Edit: lets the user make changes to the selected tool.
Delete: deletes the selected tool.
RELEASE TOOL: releases the tool with the configured lock.
LOCK TOOL: locks the tool with the configured lock.
RESET LOCKS: lock the tool with the configured lock signal and then releases all other available lock signals.

In this Section

Connection Type Setting
Lock Type Setting
Input Groups Setting
Advanced Section Configuration
Creating a Tool for ILS
Creating a Tool for Arm Systems
Creating a Tool for ILP