Test run

In the Home page, tap Configuration > General settings > Test run. The following is displayed:

  • Enable transducer from minload: when the checkbox is unselected, the transducers whose minimum operating range value is lower than the inspection minimum torque value can be used to run the test.
    When the checkbox is selected, the transducers whose minimum load value is lower than the inspection minimum torque value can be used to run the test.
    By default, the Enable transducer from minload checkbox is disabled.

NOTICE

The accuracy of the measurements is guaranteed only within the declared transducer operating range.

  • LED ring timeout: type the value in milliseconds after which the OK (green) and NOK (red) LEDs on the STbench turn off.

    If the value is set to 0 ms, the LED ring is always white.

  • Use brake over nominal torque: by selecting this check box, it is possible to run tests on the STbench brakes where the inspection maximum torque exceeds the brake operating range.

  • Force tuning tightenings: by selecting this check box, tests on the STbench brakes always start with the optimization of the braking.