Operating the Drill

Press the trigger.

The selected drill program on the display will be used when the trigger is pressed.

The tool will carry out status checks before drilling can be carried out:

• Temperature

• Battery voltage

• Internal voltage

The tool will start if all is OK.

The tool will not start the drill program if there are any discrepancies. The display will show the tool event.

Drill a hole.

While drilling, the position of the trigger is continuously used to determine the desired speed of the motor.

The tool monitors the time that the drill program has been running in order to impose a maximum time limit of 30 seconds.

End drilling

The following reasons will stop the drilling:

• Stop pressing the trigger.

• The drill program restrictions have been met.

• Supervision limits have been met.

When the drilling ends the cutter usage and the display will be updated. If any discrepancies have occurred during drilling, it will show on the display.