Assembly of Panel PC
Only approved personnel may assemble and operate this device. Only suspended or standing assembly with standard screen orientation is permitted. No vertical screen orientation is permitted.
Assemble the console as follows:
Preassemble both bottom screws on the panel PC.
The original size of the screws is M6x18. The distance between the panel PC and screw head should be approximately 13 mm.
Loosen the two screws of the connection console cover and remove the cover.
Slide the preassembled screws of the panel PC into the bottom holes of the console. Install the two upper screws and tighten all four screws.
Connect all cables to the industrial PC and put the cover of the connection console back in place.
Suspended assembly:
Standing assembly:
