Opening/Closing the Panel PC

Remove the four screws on the back of the PC unit.

Carefully lift up the back unit of panel PC max. 25° to make internal cabling to the front unit accessible. Be careful to not damage LVDS, USB and backlight cables.

Disconnect all cables carefully from the front unit of the panel PC before removing the parts from each other. The connectors are small and must be handled with care so as not be accidentally destroyed. This applies in particular to the display connectors.

Put aside the front unit with care to not damage the glass surface while maintaining the back unit.

Assemble in reverse order. Make sure not to damage the yellow gasket and ensure that the gasket is in the right place before closing the housing. Put all screws back in place and tighten lightly. Then apply a torque of 1.4 Nm to each screw.

By opening the Assembly Control Node housing all warranty claims are lost!