1. QA Supervisor
2. References
3. Advanced parameters for Joint check inspections

Advanced parameters for Joint check inspections

Strategy: residual torque/angle

• Cycle start: the cycle start is the starting point of the test.

  It must be higher than the transducer Minimum Load and equal/lower than the final angle monitoring torque.

  The default value is 0 N·m.

• Ratchet time (*): type the value of the ratchet time.

• Change screw (*): type the value of the change screw.

• Final angle monitoring torque (*): type the value of the final angle monitoring torque.

• Residual angle threshold (*): type the value of the residual angle threshold.

• Breakaway angle threshold (*): type the value of the breakaway angle threshold.

• Torque correction coefficient (*): type the value of the torque correction coefficient.

• Angle correction (*): type the value of the angle correction.

Strategy: residual torque/peak

• Cycle start: type the value of the cycle start.

  It must be higher than the transducer Minimum Load and equal/lower than the final angle monitoring torque.

  The default value is 0 N·m.

• Ratchet time (*): type the value of the ratchet time.

• Change screw (*): type the value of the change screw.

• Final angle monitoring torque: type the value of the final angle monitoring torque.

• Angle target: type the value of the target angle.

• Torque correction coefficient (*): type the value of the torque correction coefficient.

• Angle correction (*): type the value of the angle correction.

Strategy: Loose and tightening

The Loose and Tightening strategy is available only with STa 6000.

• Cycle start: type the value of the cycle start.

  It must be higher than the transducer Minimum Load

  The default value is 0 N·m.

• Change screw (*): type the value of the change screw.

• Angle target: type the value of the target angle.

• Torque correction coefficient (*): type the value of the torque correction coefficient.

• Angle correction (*): type the value of the angle correction.