Check and adjust the brush

Load the screws into the scooping chamber, turn ON and OFF the power switch so that screws are alligned into the rail groove

Turn the power switch ON and then turn it OFF when the brush is in horizontal position with the screws facing up.

Check that the heads of the screws, in the rail groove, are in slight contact with the brush bristles. If the brush height is too high or low, this will have an adverse effect on the screw allignment and transport.

If any adjustment is necessary, loosen the brush height adjusting screw to adjust the brush height.

If the plastic portion, at the front of the brush. comes into contact with the passing plate, loosen the brush assembly mounting screw and make an adjustment either backward or forward

Operate the machine to check that the brush operation is normal.