General Settings

Front LED

On: Front LED is lit when the dedicated button is pressed.

Off: Front LED will always be off.

TAG selection

On: Select the Tightening Program/Batch or Batch Sequence according to the TAG number configured in the Batch Sequence/Source Tightening/Source Batch.

Off: The tool does not select the Tightening Program/Batch or Batch Sequence.

TAG

On: Information on the TAG is displayed and can be edited in the Integrated Controller Tool > Tool menu.

Off: Information on the TAG will not be displayed.

Buzzer

On: Audio signaling device will always be on.

Off: Audio signaling device will always be off.

Keyboard source

On: It is possible to select, start and stop tightening programs and batches directly from the tool's EHMI.

Off: The EHMI can only be used to navigate the available menus and to acknowledge necessary dialogs on the EHMI screen.

Vibration

On: Vibrating device will always be on.

Off: Vibrating device will always be off.

Loose pre-tightening check

On: Accidental unscrewing of an already tightened joint is detected before the tightening starts.

Off: Function deactivated.

Smart zeroing

On: If the STRwrench detects any movement during the zero adjustment, the zeroing procedure will start over again.

Off: If the STRwrench detects any movement during the zero adjustment, the zeroing procedure will not start over again.

Gauge indicator

On: During the tightening, on the EHMI a gauge indicator gives a visual feedback on the progress of the ongoing tightening. According to the operation's settings, the gauge indicator can display torque progress, angle progress or both.

Off: During the tightening, on the EHMI only the numerical values of torque and / or angle are displayed to give a feedback on the progress of the ongoing tightening.