Safe Storage
When the work is finished, make sure the following is done:
The pressure is completely released from the tensioner which means it shows zero pressure on the hand controller and also on the analogue gauge of the pump.
Take a backup of all reports before leaving site.
The bar codes of the flange or other identifiers were scanned or noted related to the tightening results.
In case of no bar code is available, the manual bar code can be entered.
Mark the last completed bolt in case of a short break.
Disconnect the pump from the main supply during overnight.
Use the black cap on the pump inlet during transportation. It prevents oil from spilling during transit up and down the tower.
Always use the certified lifting point on the frame marked at the back of the tensioner.
Point and click on image to see more information:1
Certified lifting point
Cover the electronic connectors on the tensioner and the pump with dust caps.
Point and click on image to see more information:1
Electronic connectors covered with dust caps
Point and click on image to see more information:1
Electronic connector covered with dust cap
Change the pump oil if the ambient temperature changes or if the pump is left unused for more than 90 days.
Put all articles back in the respective boxes in the allocated positions.