Tightening error codes

Trigger lost

Tool trigger released before tightening was done.

Bit slip detected

The bit slipped out of the screw. It is recommended to replace the bit if this occurs often. (Can be enabled/disabled per Pset). Please note that this should not be turned off in Seating control steps because it may cause erroneous(false) seating triggers.

Damaged thread detected

The thread has been damaged and the screw cannot build up any more torque.

Re-hit detected

A screw was re-tightened. This can be enabled/disabled per Pset.

Seating was not detected

No seating point was detected.

Total time exceeded

The global maximum time limit for the tightening was exceed.

Global time not reached

The global minimum time limit for the tightening was not reached.

Time exceeded

The Pset step maximum time limit for the tightening was exceed.

Time not reached

The Pset step minimum time limit for the tightening was not reached.

Torque high

The Pset maximum torque limit was exceeded.

Torque low

The Pset minimum torque limit was not reached.

Angle high

The Pset maximum angle limit was exceeded.

Angle low

The Pset minimum angle limit was not reached.

Total angle high

The global maximum angle limit for the Pset was exceed.

Total angle low

The global minimum angle limit for the Pset was not reached.

Tightening angle high

The torque step maximum tightening angle was exceeded. The tightening angle is the angle from the angle trigger torque to the target torque.

Tightening angle low

The torque step minimum tightening angle was not reached. The tightening angle is the angle from the angle trigger torque to the target torque.

Seating angle high

The maximum clamp angle was exceeded. This can only happen in a Seating control step or a Torque seating monitoring step. The clamp angle is the angle from seating to finished tightening.

Seating angle low

The minimum clamp angle was not reached. This can only happen in a Seating control step or a Torque seating monitoring step. The clamp angle is the angle from seating to finished tightening.

Seating torque high

The maximum clamp torque was not reached. This can only happen in a Seating control step or a Torque seating monitoring step. The clamp torque is the torque from seating to finished tightening.

Seating torque low

The minimum clamp torque was not reached. This can only happen in a Seating control step or a Torque seating monitoring step. The clamp torque is the torque from seating to finished tightening.

Clamp angle low

Clamp angle is above upper limit.

Clamp angle high

Clamp angle is below lower limit.

Clamp torque high

Clamp torque is above upper limit.

Clamp torque low

Clamp torque is below lower limit.

Rescinding torque error

Torque dropped below rescinding torque limit during tightening