Station barcode

The station barcode can be manually entered to create a QR code containing information about the tool and controller which can be sent to the IAM QA controller via a scanner.

Parameter	Description
Tool serial number	Serial number of the tightening tool.
Controller serial	Serial number of the tightening controller.
Controller ID	Controller ID of the tightening controller.
Station ID	Station ID of the tightening controller.
Line ID	Line ID of the tightening controller.
Verification program instance no	Tightening program number.
Tool type	Type of tool that will perform the tightening.
Calibration date	Date of tool calibration. Expressed in YYYY-MM-DD.
Target torque	The amount of torque the controller will tighten to and the measurement target.
Control limit	Max allowed deviation from target/tool and used to calculate the CMK.
Verification size	Number of tightenings to perform for the testing of the tool.
Minimum CMK	Minimum value CMK can have to report a verification OK (if CMK is below min value the verification will report NOK). If parameter is empty or set to 0 then the verification will evaluate the result according to the measurement results.
Operator ID required	No = QA can start the verification regardless if an operator ID is active or not. Yes = QA cannot start the verification unless an Operator ID is active.

Save

Saves the QR code and all parameters as a picture in .jpg or .bmp format on your computer.
Export

Saves the parameters in an .xml file on your computer which can be imported and re-edited at a later time.
Import

Imports an existing .xml file containing all the parameters and their values.
Print

Prints the QR code and all parameters in a nice format that is ready to be placed next to the tightening station.
Load parameters

Load active controller parameters into the appropriate fields. Parameters that will be loaded into the station barcode are:
- Tool serial number
- Controller serial number
- Controller ID
- Station ID
- Line ID
- Tool type