1. SP-700-230
2. Troubleshooting
3. Hydraulic unit does not start

Hydraulic unit does not start

• Verify that the hydraulic unit is properly connected to the main supply and that the hydraulic fluid level is correct.

• Verify that the Emergency Stop Switch is not pressed.

• Verify that the power of your generator (if used) is sufficient and that the section of cable is suitable for the length of it. (See chapter II-3).

As a good practice, it is always recommended perform the starting of a hydraulic device without pressure. Pay attention that if the working conditions are below 10˚C or cable length is very long, you should open the regulating pressure valve to start the pump.