Operating in MANUAL mode

  1. Select Manual Mode by changing the automatic / manual mode button on the pendant. This message is displayed in the screen.

  2. Connect the hose and the wrench properly. Press the green button to start the pump. Press it again to set the working pressure while turning the pressure regulating valve. Do this until you reach the desired working pressure according to the conversion chart and the model of torque wrench.

  3. Now place the wrench over the bolt to be tightened. Press the green button to perform as many tightening cycles as needed, like any other “manual” torque pump.

If the Automatic Mode was set and as long as the pump is not unplugged, we can change between Automatic and Manual mode with the grey button.

It is important to note that if the hoses are changed or the wrench is unplugged, WE WILL HAVE TO REPEAT THE LEARNING.