Pairing the IRC-Connect with a remote device

In order to connect the IRC-Connect to a remote device, tool and device must first be associated through a pairing procedure.

The pairing procedure is required only once before the first connection to a remote device: once the IRC-Connect is paired to the remote device, the user can directly connect them in every moment.

To pair the IRC-Connect with a remote device, do the following:

  1. Switch both the remote device and the IRC-Connect on.

  2. Set the remote device up in order to enable the IRC-Connect connection. For further information refer to the User Guide specific to the remote device in use.

  3. On the IRC-Connect main panel:

    • press the power switch three times, if you are pairing the tool with an STa 6000 / STa 6000 Plus.

    • press the power switch five times, if you are pairing the tool with an STpad.

    The reference STpad firmware version is 07.02a and later.

    • press the power switch five times, if you are pairing the tool with an STpalm.

    During the pairing procedure, the Radio LED is steady on, while the Results LEDs blinks together.

  4. Start the pairing procedure on the remote device.

For further information, respectively refer to STa 6000/STa 6000 Plus User Guide, STpad Configuration Manual and STpalm Configuration Manual.