Adjusting the Free Speed
The AutoTrim valve is factory set to approximately 70% of full speed. To reduce the free speed, reduce the length of L. To increase the free speed, increase the length of L.
Adjust the length of L by turning the support ring (1).
On very hard joints (<30°) at low torque levels, further speed reduction might be necessary. When the tool is used only on soft joints, less or no speed reduction is needed.
The factory set length of L is depending on the tool size, see table.
AutoTrim Valve | Length of L (mm) |
|---|---|
4250 1878 43 | 39.2 +/-0.1 |
4250 1878 90 | 39.2 +/-0.1 |
4250 1878 91 | 39.7 +/-0.1 |
4250 1878 92 | 40.2 +/-0.1 |
4250 1878 93 | 40.7 +/-0.1 |
4250 1878 94 | 40.3 +/-0.1 |
4250 1878 95 | 40.5 +/-0.1 |
4250 1878 97 | 39.2 +/-0.1 |
4250 1878 98 | 39.7 +/-0.1 |
4250 2675 91 | 40.5 +/-0.1 |
4250 2675 92 | 40.3 +/-0.1 |
4250 1878 50 | 38.7 +/-0.1 |
4250 1878 51 | 38.7 +/-0.1 |
