Trace Category

The Trace category shows the traces acquired for each result in the inspection.

If the Double result function is enabled, both the residual point and the peak point are shown in the plot as circles.

The Trace category provides the following functions:

Navigating the results' traces inside the inspection. To do so, tap Next and Back .
The result sequence number is displayed in the bottom-right corner of the screen, preceded by #:.
Viewing the plot in full-screen. To do so, tap Full-screen .

In full-screen mode, it is possible to select and zoom-in on a section of the curve. To do so, pinch two fingers apart on the section to zoom-in and tap on the rectangular selection that appears. To reset the plot view, tap Zoom reset .

Tap Close to exit the full-screen mode.
Selecting plot type. To do so, tap Plot type and select the plot type to display from the following options:
- Torque over Time
- Angle over Time
- Angle/Torque over Time
- Torque over Angle
The default plot type is Torque over Angle.