Viewing Tool Information

Model

Measuring device model denomination.

Serial Number

Measuring device serial number. It may be needed for the correct spare parts list or for service instructions.

Product Number

Measuring device product number.

Model

smartHEAD model denomination.

Serial Number

smartHEAD serial number. It may be needed for the correct spare parts list or for service instructions.

Maximum Torque

smartHEAD torque capacity.

Product Number

smartHEAD product number.

TAG ID

TAG number.

Torque Correction Coefficient

Torque correction coefficient defined for the TAG.

Angle correction

Angle correction defined for the TAG.

Nominal torque

Torque at which the Angle correction is defined.

Is transducer overloaded?

Yes - the transducer has been overloaded.
No - the transducer has not been overloaded.

Highest torque value

Highest torque output measured by the transducer.

Highest torque date

Date and time when the highest torque output was measured by the transducer.

Angle correction

Angle correction coefficient for the smartHEAD due to the wrench bending.
Note that this coefficient is related to the torsion of the smartHEAD itself. When a wrench extension is used, its angle correction coefficient must be calculated and added to the end fitting tool or inspections parameters. For further information, refer to How to Calculate the Angle Correction.

Transducer calibration date (CW)

Date of the last torque calibration in clockwise direction.

Gyro calibration date (CW)

Date of the last gyroscope calibration in clockwise direction.

Transducer calibration date (CCW)

Date of the last torque calibration in counterclockwise direction.

Gyro calibration date (CCW)

Date of the last gyroscope calibration in counterclockwise direction.

Next calibration date

Date of the next calibration expiration.

Number of measurements

Number of measurements performed by the transducer so far.