Feed rate
The feed rate of the drill must be balanced with the spindle speed. Make a selection from the available combinations of feed rate in the table below to get the desired feed rate. Normally a feed cassette can define two feed rates. By turning it 180 degrees you can change the feed rates, as shown in the figure below.
Feed cassette | ||
---|---|---|
IPR | mm/rev | Ordering No. |
0.001 | 0.023 | 4141 0034 91 |
0.002 | 0.05 | 4141 0034 92 |
0.003 | 0.075 | 4141 0034 93 |
0.004 | 0.10 | 4141 0034 94 |
0.006 | 0.16 | 4141 0034 95 |
0.008 | 0.21 | 4141 0034 96 |
0.010 | 0.27 | 4141 0034 95 |
0.013 | 0.33 | 4141 0034 94 |
0.014 | 0.36 | 4141 0034 93 |
0.015 | 0.38 | 4141 0034 92 |
0.016 | 0.42 | 4141 0034 91 |
