Viewing the details of the inspection results
In the Results page, click the inspection to view. The Result details page opens.
The General category lists the parameters of the selected inspection. The parameters change depending on the inspection selected into the Results page.
The General category is a read-only page.
The Results category lists the single results done during the inspection. If a result is NOK, the related value is highlighted with a red colored bar.
If during the test run a measurement is deleted or is not detected, it is deleted from the Measure page, but it is displayed in the Results category.
Not detected measurements are marked with a dash.
Deleted measurements are grayed out.
Measurements not detected and deleted are marked with a dash and are grayed out.
Tap a single value to open the Measure page, where the general information of the test are displayed.
In the Trace category, the acquired trace is shown.
If the trace has not been acquired, the Trace category is not displayed.
In the Photo category the photo saved during test run are shown.
In the Traceability tag category, the used traceability tags, the assignable causes, the corrective actions and the comments added during the test run are shown.
