Source Tightening Overview
The tightening menu shows a list of Source Batch and Source Tightening configurations. Separate lists can be linked to a Virtual Station by going to the Virtual Station in question, and in the Task properties selecting Choose. There, a Source can be chosen as a task. Source tightenings link a specific tightening program to an identifier number. When the identifier number is sent to the controller, the linked program will run over and over until a different signal is sent .
Parameter name | Description |
|---|---|
Name | The name issued to the Source Tightening. |
Description | The description of the Source Tightening. |
Lock tool on batch sequence complete | On: The tool is locked when the batch sequence is completed. Off: The tool remains unlocked when the batch sequence is completed. |
Increment on NOK | On: The batch will advance even if a NOK tightening is performed. Off : The batch will only advance if a successful tightening is performed. |
Max consecutive NOK per program |
|
Max consecutive NOK | Set the number of consecutive NOK results to be allowed. If the value is set to 0, then there is no check performed for NOK tightenings. When reaching max consecutive NOK's, the controller locks the tool and the source tightening execution is halted. |
Batch control | Select how the source tightening is to be executed:
|
Command | Description |
|---|---|
Add | Adds a new row with lowest identifier available. |
Delete | Removes selected sync mode from the list. Select the sync mode by selecting the corresponding check box. |
