Upgrading ToolsTalk 2

Before start of the upgrade make sure that:

the ToolsTalk2 server runs.
a backup of the database is done.

If the service stop during an upgrade and does not automatically start again, error messages are shown.

When upgrading ToolsTalk 2 from 2.12 or earlier versions and Atlas Copco Data Communication (ACDC) is already installed, make sure that the controller port is pointing to the same port that ACDC was installed on. If you are installing ACDC for the first time and want to use another port than your current controller port in your ToolsTalk 2 version, then change the controller port as described in the following procedure.

In the configuration files, controller port is named as HubPort.

In ToolsTalk.Server.SelfHostService.exe.config(ClickOnce/Client/Server) or ToolsTalk.Standalone.exe.config(Station Setup), change the controller port to the correct port number <add key="HubPort" value="XXXX" />