All Signals
Name in SoftPLC: CYCLE_STATUS_ALL
Value Type | Size Min [bit] | Size Max [bit] |
|---|---|---|
Integer | 1 | 32 |
Table of Contents
- Introduction
- loading...
- Installation and Upgrade
- loading...
- Configuration
- Getting started
- loading...
- Quality Integrated Fastening Accessories (QIF)
- Working with the Batch Sequence Tab
- loading...
- Working with the Configurations Tab
- loading...
- Working with the Controller Information Tab
- loading...
- Working with the Fieldbus and SoftPLC Tab
- loading...
- Working with the Libraries Tab
- loading...
- Working with Push Configuration Changes
- loading...
- Working with the Settings Tab
- loading...
- Working with the Sources Tab
- loading...
- Working with the StepSync System
- Hardware Configuration [TT2]
- loading...
- Sync Mode
- loading...
- StepSync Signals
- Input Signals
- Output Signals
- Input/Output Signals
- Input Signals: Sub-signals
- loading...
- Output Signals: Sub-signals
- Bolt Tightening Status - 79: Sub-signals
- loading...
- Channel Tightening Status - 80: Sub-signals
- loading...
- Channel Hardware Status - 81: Sub-signals
- All Signals
- Drive Disconnected
- Drive Temp High
- Drive Voltage Error
- Emergency Stop Active
- General Hardware Error
- Motortune Needed
- Tool Cable Invalid
- Tool Disconnected
- Tool Temp High
- Torque Transducer Error
- Sync points
- Working with Fieldbus, SoftPLC and Acyclic Data Tab
- loading...
- Working with the Sources Tab
- loading...
- Enabling and Disabling the Tightening Settings
- Working with the System Administration Tab
- loading...
- Working with the Tightening Program Tab
- loading...
- Working with the Tools Tab
- loading...
- Working with the Virtual Station Tab
- loading...
- Reports and Statistics
- loading...
- Troubleshooting and Service
- loading...
- Reference
- loading...
- Glossary
Smart Connected Information
