1. ToolsTalk 2
2. Configuration
3. Working with the Fieldbus and SoftPLC Tab
4. Fieldbus Requirements

Fieldbus Requirements

For correct fieldbus communication, the following installations and configurations must be made. This is done in the Fieldbus and SoftPLC tab.

• A fieldbus module is installed on the controller.

• Common fieldbus parameters set in the menus in the Overview sub - tab.

• Signal configurations are created in the Fieldbus sub-tab, which are then mapped in the Fieldbus Virtual Station Mapping Configuration menu in the Overview sub - tab.

• Items mapped into fieldbus maps in the Signal Configuration menu, located in the Fieldbus sub - tab.

• Fieldbus maps assigned to virtual stations and placed into the Process Data Frame in the menus in the Fieldbus and SoftPLC tab.