Running a Loosening Sync Mode Using the Input Select Loosening

Select a tightening sync mode with an associated loosening sync mode.

• This can be done by adding the I/O signal Select Input, Id 10020 in the To controller area in the Fieldbus sub-tab under Fieldbus and SoftPLC or this can also be done by selecting a task in the Task under the Virtual Station tab .

Select loosening using the I/O signal Select loosening, Id 10029 in the To controller area in the Fieldbus sub-tab under Fieldbus and SoftPLC .

Start the loosening using any of the two signals:

• Start drive (continuos), Id 10028

• Start drive (pulse), Id 10113