Validating the Client-Server Installation

After successful installation of the client-server version of the ToolsTalk 2 application, a Power Focus 6000 controller is needed for a complete system test.

The server computer must be connected to the network.
The client computer must be connected to the network.
The controller must be connected to the network and configured to communicate with the server computer.

The server and client may be installed on the same computer.

For configuration and starting the controller please refer to the Power Focus 6000 controller configuration guide.
For configuration, starting and navigating in the ToolsTalk 2 GUI, please refer to the ToolsTalk 2 configuration guide.

If the ToolsTalk 2 client is installed, the application can be started in the following way:

Select the Windows Start menu and locate the ToolsTalk 2 folder.
Select the ToolsTalk 2 icon to launch the application.

The Getting started section in the ToolsTalk 2 configuration manual describes the windows and the window navigation.