STwrench start step parameters

The parameters shown in the tables are available if one of the STwrench strategies are used. There are several combinations of strategies. Some of the parameters are only available for certain strategies and may not be visible in other strategies.

Parameter rules are automatically checked. If a violation occurs, the error indicator is displayed beside the incorrect parameters. Place the cursor on the error indicator to display more information about the error.

Switching between strategies can result in the error indicator being shown. This indicates that the chosen combination is invalid, and needs to be corrected.

More details about the parameters are given in the STwrench user guide, document number 9836 4134.

Parameters in the STwrench start step
Parameter name	Condition	Description	Default value
Tag number		On: a correct TAG number is required to run this tightening program. Off: The TAG number is not checked.	Off
Required tag number	Tag number = On	The required TAG number for this tightening program.	1
Rehit detection		The parameter options are: Complete or Off .	Off
Torque correction coefficient		In certain cases extensions may be needed to fit the application. In this case the wrench measurement must be compensated to show a correct value. To calculate the correction coefficient, please refer to the STwrench user guide, printed matter nr 9836 4134 01 edition 2.12. The parameter is stored in the RFID TAG in the End-fitting tool.	1.0
Angle correction		In certain cases extensions may be needed to fit the application. In this case the wrench measurement must be compensated to show a correct value. To calculate the correction coefficient, please refer to the STwrench user guide. The parameter is stored in the RFID TAG in the End-fitting tool.	0°

NOTICE

The correction coefficients alter the STwrench measurement. It may cause an improper reading. Please refer to the STwrench user guide, printed matter nr 9836 4134 01 edition 2.12, before making any corrections.