Output Signal Configuration
An Output Signal can be mapped to a lamp, a stacklight, a siren, a buzzer or a terminal connector. The signal is valid during a programmable duration, or until the next tightening starts.
All the different accessories show where and how an output signal can be mapped.
Mapping an output signal to a position:
Select a component or a position.
Select a Signal from the drop-down menu.
Set the Duration switch to Time or to Next tightening.
If Time is selected, a parameter entry box is displayed. Enter the duration of the output signal in seconds.
Set the Pulsating position switch to On for a flashing or intermittent signal, or to Off for a steady signal.
If the position is a stacklight, a Rotating option is also possible.
