1. ToolsTalk 2
2. Installation and Upgrade
3. Upgrading ToolsTalk 2

Upgrading ToolsTalk 2

Before starting the upgrade:

• make sure the ToolsTalk2 server is running.

• backup the database.

If during an upgrade, service is interrupted and does not restart automatically, messages describing the nature of error are displayed.

When upgrading ToolsTalk 2 from 2.12 or earlier versions and Atlas Copco Data Communication (ACDC) is already installed, make sure that the controller port is pointing to the same port that ACDC was installed on. If you are installing ACDC for the first time and want to use another port than your current controller port in your ToolsTalk 2 version, then please change the controller port as described in the following procedure.

In the configuration files, controller port is named as HubPort.

• In ToolsTalk.Server.SelfHostService.exe.config(ClickOnce/Client/Server) or ToolsTalk.Standalone.exe.config(Station Setup), change the controller port to the correct port number <add key="HubPort" value="XXXX" />