Mounting the Tensioner

Connect the balancer to the lifting eye bolt, see the picture.

Do not lift the tensioner from any other point.

Move the tensioner above and in line with the bolt, close to the top mounting position.

Run down the tensioner on the top of the bolt keeping clear from the adjacent bolt/washer till it touches the flange face.

Hold or secure the tensioner with a lifting device.

Engage the manual click wrench to the 3/8” square drive on the top of the manifold.

The click wrench should not be set to more than 75 Nm as it can damage the IRTT inside the tensioner.

Turn the click wrench clockwise to engage the socket inside the tensioner.