Rotate

The Rotate strategy is mainly used for testing and demonstration. When the tool can rotate freely, it turns the socket by the specified angle using the lowest possible torque.

The Rotate strategy is the updated version of the Rotate Legacy program. The intended use of the new program is the same as the previous version. The new program provides similar tightening behavior and a similar configuration interface. However, it uses a different implementation method. All configuration elements, such as step descriptions and applicable parameters, are also valid for the Rotate strategy program.

Parameter	Description	Default value
Target speed	Target speed for the Rotate strategy.	69 rpm
Target angle	Angle to turn the spindle.	360°
Torque max	Defines the upper torque limit during program execution. If the torque exceeds this limit, the tightening stops. The system shows an error message, and the tightening result is marked as NOK.	1 Nm

Rotate Legacy

The Rotate Legacy strategy was previously named Rotate strategy. It is the same tightening strategy, but it was renamed when a new version was introduced.

Parameter	Description	Default value
Target speed	Target speed for the Rotate strategy.
<Target speed>	Manual tool speed during the Rotate strategy.	16.5% of Tool max speed
Target angle	Angle to turn the spindle.	360°