Setting up Synchronized Tightening (hardware)

Note that software configuration needs to be done before hardware set-up is completed in order to avoid possible set-up conflicts.

The synchronized tightening function allows several POWER FOCUS 6000 to be connected in order to run synchronized tightenings.

  1. Make sure each controller has been configured correctly (see Synchronized Tightening Configuration for more information).

  2. Using a Power Focus 6000 daisy-chain cable, connect the Sync Reference Com Port B to the first Sync Member's Com Port A.

  3. Using another PF6000 daisy-chain cable, connect the first Sync Member's Com Port B to the second Sync Member's Com Port A. Do the same for all subsequent controllers.

    A synchronized tightening system can be configured with a maximum of 5 Sync Members.

A

Sync Reference

D

Connected to Com Port A

B

Sync Member

E

Power Focus 6000 daisy-chain cable

C

Connected to Com Port B

Relevant Information